Brembo PS 15 rear master cylinder for models with a remote reservoir. Supplied with operating lever. Mounting holes at 50mm centres

Also known as Guzzi ref. also known as Guzzi ref. 30666960, 65660200, 10477665, 31666990. Brembo ref. 10.2934.02 Discontinued by Brembo- See BRA19001 for alternative part

 Sorry, this part is no longer available.

 19667000 GU19667000 19 66 70 00
 1966 7000 1966.7000 19.66.70.00

Brembo PS 13 handlebar mounted front master cylinder. The PS13 has a small rectangular fluid reservoir

Replaces Guzzi refs 28660178 and 30660180. Supplied complete with black or polished lever. Uses switch ELA30860

 This part is due back in stock soon, call 01484 841395 to reserve yours

 28660278 GU28660278 28 66 02 78
 2866 0278 2866.0278 28.66.02.78

Pair of Hagon progressive fork springs

These progressive fork springs improve ride quality and handling by responding progressively to the road. The more the spring is compressed the harder it becomes preventing the forks from bottoming out. Supplied with instructions, see OIA02075 for fork oil

 This part is available by special order, request a quote

Pair of Wirth progressive fork springs

These progressive fork springs improve ride quality and handling by responding progressively to the road. The more the spring is compressed the harder it becomes preventing the forks from bottoming out.

For 16 inch front wheel models. See OIA01001 for fork oil

 This part is available by special order, request a quote

The Power Commander is a fuel injection and ignition timing (on some models) adjustment unit that plugs "inline" with the bikes' stock ECU. The Power Commander uses original equipment style connectors so that no splicing or cutting of the harness is required. Most installations take less than 15 minutes, some as little as 5 minutes. Changes are made to the bikes fuel and ignition curves via the Power Commander's onboard microprocessor. Using this technology we are able to offer a large area of adjustment without making any permanent changes to the bikes' ECU (electronic control unit). Removing the Power Commander returns the bike to its previous stock condition. The Power Commander can be ordered preprogrammed with a your choice of several settings, based on the modifications to your bike. The unit also comes complete with software and cable link that allows you to change between different maps or make adjustments to a map file.

This is for V7 models with twin throttle bodies, it is not compatible with single throttle body models

 This part is available by special order, request a quote

Short alloy bellmouth / trumpet intake with domed mesh for Dellorto PHBH 30 carb, replacing air filter. Clamp on type

Supplied with fixing clip, carb shown is for illustration purposes

 This part is available by special order, request a quote

Pod type air filter for increased air flow

Made from a high performance twin layer foam this K & N type air filter is designed to offer improved and unrestricted airflow whilst offering adequate filtration. Washable and reusable (use hot soapy water). Best run dry for road. Fits VHB 29, VHB 30, PHBH28 and PHBH30 Dellorto carbs. You may find that a 5-10% increase in main jet size helps to make the most of the increased air flow with this filter

 This part is available by special order, request a quote

Rubber grommet for clutch bell housing / flywheel timing hole

Timing hole plug or timing hole bung. Also used to fill holes used to mount Griso factory luggage rack

 More than 5 in stock

93180220-z 93180220 GU93180220 93 18 02 20
 9318 0220 9318.0220 93.18.02.20

Red NGK spark plug resistor cap with rubbers

Also known as suppressor cap

 Sorry, this part is no longer available.

LD05F

Black NGK spark plug resistor cap with rubbers

Also known as suppressor cap

 More than 5 in stock

LD05F